You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
Repository navigation
Flat finishing: accept CAD floor boundaries and an optional final wall pass #371
#359 replaces Flat’s raster rows with contour-parallel finishing and retains facet-based clearance checks. Two improvements listed in #38 remain outside that change. Flat still derives horizontal levels from the surface mesh, and callers can leave radial stock for a separate wall operation but cannot request a final wall pass within Flat.
Allow callers with CAD geometry to supply the horizontal face boundaries, with their holes and declared boundary error. Use the existing CadQuery floor-region export where applicable. The headless engine must continue to accept mesh-only jobs.
Allow an explicitly requested final wall-following pass with defined radial allowance semantics. Verify it independently against the target and remaining stock.
Cover a circular boundary, a level with holes, and a mesh-only job. Check the posted path and material results for the optional wall pass.
Activity
Flat: contour-parallel offset passes, area by area, with arc entries (s…