P2P commands to ESP units not working.

[Budman1758]

@enesbcs Welcome back dude! Great to see this!

I have this installed on a RPI 5 and have tried to send commands to other units on my network and so far it does not work. The sendto command shows as executed on the PI but the target unit either does not respond or the log says "unknown command". I think RPIEasy is sending but not correctly for the target unit to understand. I believe it may have to do with the issue of needing to wrap the commands in quotes. I have tried with and without quotes and the result is the same.

Also the "SendToHttp" command does not seem to be recognized by RPIEasy.

[enesbcs]

The p2p handler did not processed incoming commands, and also found a parsing problem in rules engine.

After fixing i've tested succesfully with the following commands:

from rpieasy to espeasy
sendtohttp 192.168.2.17,80,"/tools?cmd=TaskValueSetandrun,1,1,2"

from espeasy to rpieasy
sendtohttp 192.168.2.19,8080,"/tools?cmd=TaskValueSetandrun,1,1,1"

from rpieasy to espeasy
sendto 3,"TaskValueSetandrun,1,1,0"

from espeasy to rpieasy
sendto 1,"TaskValueSetandrun,1,1,2"

Please download as ZIP and upgrade your installataion:
https://github.com/enesbcs/rpieasy2/archive/refs/heads/main.zip

[Budman1758]

After the upgrade it seems to be working now.

However, the upgrade method of uploading the zip file does not appear to be working. When uploading the file, I get an instant page that says success but upon looking at the version in the system info page it is unchanged.

I was able to upgrade using the install script. I did notice this behavior the first time I tried upgrading after the initial install also.

Sendtohttp is also working. Rules were enabled also when it didn't work

[enesbcs]

Interesting, update from webui is the only function that always worked for me. :) Although it takes a while on an RPI Zero W ~10-12 seconds,

[Budman1758]

Although it takes a while on an RPI Zero W ~10-12 seconds,

The unit I am working on is a PI 5 4GIG. The "success" page comes up almost before I click upload.

[enesbcs]

If you can enter linux console through SSH for example, there is a run.sh next to the main.py. If you start it like:
./run.sh log
then it will show you debug console logs from running RPIEasy.

In case you send me the logs from the upgrading event, i can check it.