Describe the bug
After correctly starting a Hypervisor Migration (Thank you, @MrMasterbay), the migration starts and runs for a little while then exits with the following:
[21:21:48] Phase: planning
[21:21:48] Source VM: WinSVR (106)
[21:21:48] Found 1 disk(s), total 60.0 GB
[21:21:48] Target VMID: 107
[21:21:48] Phase: transfer
[21:21:48] Transferring WinSVR 0 (60.0 GB)
[21:21:50] Allocated local-zfs:vm-107-disk-0
[21:24:54] FAILED: Transfer error: ("Connection broken: BrokenPipeError(32, 'Broken pipe')", BrokenPipeError(32, 'Broken pipe'))
[21:24:54] Phase: failed
I tried a few times, even restarted the systems and tried again with the same errors.
On the target PVE i do see a disk being created..
The failure almost always happens at the 2nd check box sometimes a little past it. It never makes it much past step 2.
Looking at the pool I can see about 11Gb was transferer
zfs list
NAME USED AVAIL REFER MOUNTPOINT
rpool 85.8G 631G 104K /rpool
...
rpool/data/vm-107-disk-0 11.6G 631G 11.6G -
rpool/var-lib-vz 1.75G 631G 1.75G /var/lib/vz
(Not sure what other logs to grab)
Environment
- PegaProx Version: 0.9.12
- **Installation Method:**ct image
- Behind Reverse Proxy? No
- UI? Corporate
Checklist
- [x ] I have searched existing issues to make sure this is not a duplicate
- [ x] I am using the latest version of PegaProx
Describe the bug
After correctly starting a Hypervisor Migration (Thank you, @MrMasterbay), the migration starts and runs for a little while then exits with the following:
I tried a few times, even restarted the systems and tried again with the same errors.
On the target PVE i do see a disk being created..
The failure almost always happens at the 2nd check box sometimes a little past it. It never makes it much past step 2.
Looking at the pool I can see about 11Gb was transferer
(Not sure what other logs to grab)
Environment
Checklist