Sometimes when changing the eccentricity slider the state will try to be evaluated at infinity. It seems to happen when the true anomaly is set above the true anomaly of the asymptote for higher eccentricities. When the eccentricity is increased the code should reset the true anomaly slider to be lower than the new true anomaly of the asymptote, however when dragging the slider it seems to lag behind a little and think that the true anomaly is greater than the new true anomaly of the asymptote. Similarly when the eccentricity is manually entered to be higher the same problem happens. It doesn't happen when clicking on the slider to increase by a single slider resolution, which as it currently stands is an eccentricity difference of 0.001.
This issue causes warning message boxes to pop up continuously.
Sometimes when changing the eccentricity slider the state will try to be evaluated at infinity. It seems to happen when the true anomaly is set above the true anomaly of the asymptote for higher eccentricities. When the eccentricity is increased the code should reset the true anomaly slider to be lower than the new true anomaly of the asymptote, however when dragging the slider it seems to lag behind a little and think that the true anomaly is greater than the new true anomaly of the asymptote. Similarly when the eccentricity is manually entered to be higher the same problem happens. It doesn't happen when clicking on the slider to increase by a single slider resolution, which as it currently stands is an eccentricity difference of 0.001.
This issue causes warning message boxes to pop up continuously.